Western multiplex Lynx 2xE1 - Page 15

INSTALLATION AND MAINTENANCE MANUAL
E1 FAMILY
LICENSED & SPREAD SPECTRUM RADIOS
JUNE 2001
TOC & INTRODUCTION iii
2. Specifications at the output ports......................................................................................................................... 5-1
APPENDIX B - REAR PANEL DIP SWITCHES......................................................................................................................5-3
APPENDIX C - REAR PANEL DATA CONNECTORS..........................................................................................................5-12
APPENDIX E – INSTALLATION AND TROUBLESHOOTING GUIDE................................................................................5-14
Figures
FIGURE 1-1: PROPER EARTHING/GROUNDING........................................................................................................................1-3
FIGURE 2-1: FRONT PANEL, 2.4 GHZ & 5.8 GHZ 1XE1........................................................................................................2-13
FIGURE 2-2: FRONT PANEL, 2.4 GHZ & 5.8 GHZ 2XE1........................................................................................................2-13
FIGURE 2-3: FRONT PANEL, 2.4 GHZ & 5.8 GHZ GHZ 4XE1...............................................................................................2-13
FIGURE 2-4: FRONT PANEL, 5.8 GHZ, 8XE1..........................................................................................................................2-14
FIGURE 2-5: FRONT PANEL, 1.5 GHZ, 2XE1..........................................................................................................................2-14
FIGURE 2-6: FRONT PANEL, 1.5 GHZ, 4XE1..........................................................................................................................2-14
FIGURE 2-7: REAR PANEL 1XE1...............................................................................................................................................2-19
FIGURE 2-8: REAR PANEL, 2XE1..............................................................................................................................................2-19
FIGURE 2-9: REAR PANEL, 4XE1 (OPTIONAL UNBALANCED, BNC PORTS).....................................................................2-19
FIGURE 2-10: REAR PANEL, 8XE1 (BALANCED, RJ-45 PORTS ONLY)................................................................................2-20
FIGURE 2-11: REAR PANEL, 1.5 GHZ, 2XE1...........................................................................................................................2-20
FIGURE 2-12: REAR PANEL, 1.5 GHZ, 4XE1...........................................................................................................................2-20
FIGURE 2-13: CEPT-1 INTERFACE GROUNDING SWITCH....................................................................................................2-22
FIGURE 3-1: CHANNEL PLAN, 2.4 GHZ 1XE1.........................................................................................................................3-39
FIGURE 3-2: CUSTOM CHANNEL PLAN, 2.4 GHZ E1.............................................................................................................3-39
FIGURE 3-3: CHANNEL PLAN, 2.4 GHZ 4XE1.........................................................................................................................3-40
FIGURE 3-4: CHANNEL PLAN, 5.8 GHZ 1XE1, 4XE1..............................................................................................................3-40
FIGURE 3-5: CHANNEL PLAN, 5.8 GHZ 2XE1.........................................................................................................................3-41
FIGURE 3-6: CHANNEL PLAN, 5.8 GHZ 8XE1.........................................................................................................................3-41
FIGURE 3-7: NEGATIVE VOLTAGE DC CONNECTION..........................................................................................................3-45
FIGURE 3-8: POSITIVE VOLTAGE DC CONNECTION ............................................................................................................3-45
FIGURE 3-9: AC CONNECTION ................................................................................................................................................3-46
FIGURE 3-10A: TYPICAL VOLTAGE VS RECEIVED SIGNAL LEVEL (RSL) FOR 1XE1, 2XE1, 4XE1.................................3-51
FIGURE 3-10B: TYPICAL RSL VOLTAGE VS RECEIVE SIGNAL LEVEL (RSL) FOR 8XE1..................................................3-52
FIGURE 3-11: CEPT-1 INTERFACE GROUNDING SWITCH....................................................................................................3-54
FIGURE 3-12A: LOOPBACK MODE SELECTION, 1/2/4XE1 MODELS..................................................................................3-56
FIGURE 3-12B: LOOPBACK MODE SELECTION, 8XE1 MODEL...........................................................................................3-56
FIGURE 3-13: SPREADING CODE SELECTION (LYNX.SC ONLY)..........................................................................................3-57
FIGURE 3-14A: INPUT ALARM DISABLE SWITCH, 1XE1, 2XE1, 4XE1..............................................................................3-58
FIGURE 3-14B: INPUT ALARM DISABLE SWITCH, 8XE1.....................................................................................................3-59
FIGURE 3-15A: AIS SWITCH, 1XE1, 2XE1, 4XE1 MODELS..................................................................................................3-60
FIGURE 3-15B: AIS SWITCH, 8XE1 MODEL ..........................................................................................................................3-60
FIGURE 3-15C: SECURITY CODE LYNX.HD 8XE1.................................................................................................................3-61
FIGURE 3-16: TYPICAL RF OUTPUT POWER VERSUS PWR VOLTAGE, 1.5 & 2.4 GHZ MODELS..................................3-64
FIGURE 3-17: TYPICAL RF OUTPUT POWER VERSUS PWR VOLTAGE, 5.8 GHZ MODELS.............................................3-65
FIGURE 3-18: ERROR LED MODE SELECTION.......................................................................................................................3-73
FIGURE 3-19: RJ-11 ORDERWIRE TELEPHONE CONNECTION............................................................................................3-75
FIGURE 3-20: VF PORT CONNECTION ....................................................................................................................................3-76
FIGURE 3-21: PIN CONNECTIONS, ALARM INTERFACE .....................................................................................................3-78