Western multiplex Lynx 2xE1 - Page 16

INSTALLATION AND MAINTENANCE MANUAL
LYNX E1 FAMILY
LICENSED & SPREAD SPECTRUM RADIOS
JUNE 2001
iv TOC & INTRODUCTION
FIGURE 3-22: DIAGNOSTIC PORT PROTOCOL SELECTION .................................................................................................3-80
FIGURE 3-23: RS-232 DIAGNOSTIC PORT CONNECTIONS....................................................................................................3-81
FIGURE 3-24: RS-422 DIAGNOSTIC PORT CONNECTIONS....................................................................................................3-82
FIGURE 3-25: REPEATER AND HUB TBOS RADIO NETWORK MANAGEMENT...............................................................3-87
FIGURE 3-26: REPEATER APPLICATION WITH SITE NETWORK MANAGEMENT ......................................................... 3-87
FIGURE 3-27: AUX DATA CABLE CONNECTION FOR REPEATER/HUB ..........................................................................3-88
FIGURE 3-28: AUX DATA SELECTION, ALL LYNX RADIOS...............................................................................................3-88
FIGURE 3-29: MHS CONFIGURATION.....................................................................................................................................3-89
FIGURE 3-30: SD CONFIGURATION.........................................................................................................................................3-90
FIGURE 4-1: BACK-TO-BACK TEST CONFIGURATION .........................................................................................................4-23
FIGURE 4-2: END-TO-END BER TEST CONFIGURATION......................................................................................................4-24
FIGURE A-1: MASK OF THE E1 PULSE (CEPT-1).....................................................................................................................5-2
FIGURE C-1: VF PORT CONNECTION......................................................................................................................................5-12
FIGURE C-2: ALARM PORT CONNECTIONS...........................................................................................................................5-12
FIGURE C-3: DIAGNOSTIC PORT 9-PIN D-STYLE CONNECTOR .........................................................................................5-13
FIGURE C-4: AUX DATA PORT 9-PIN D-STYLE CONNECTOR .........................................................................................5-13
Tables
TABLE 3-A: DC POWER CONNECTION FOR NEGATIVE SUPPLY ......................................................................................3-43
TABLE 3-B: DC POWER CONNECTION FOR NEGATIVE SUPPLY.......................................................................................3-43
TABLE 3-C: TRANSMITTER OUTPUT POWER ADJUSTMENT, +6 DBW EIRP INSTALLATIONS...................................3-68
TABLE 3-D: TRANSMITTER OUTPUT POWER ADJUSTMENT FOR 2.4 GHZ, USA INSTALLATIONS............................3-69
TABLE 3-E: ALARM INTERFACE CONNECTIONS..................................................................................................................3-79
TABLE 3-F: TBOS MAP FOR THE LYNX E1S.........................................................................................................................3-84
TABLE A-1: CEPT-1 INTERCONNECTION SPECIFICATION ..................................................................................................5-1
TABLE B-1: LYNX.SC 1XE1, 2.4 GHZ SWITCH SETTINGS.....................................................................................................5-4
TABLE B-2: LYNX.SC 1XE1, 2.4 GHZ SWITCH SETTINGS.....................................................................................................5-5
TABLE B-3: LYNX.SC 1XE1, 5.8 GHZ SWITCH SETTINGS......................................................................................................5-6
TABLE B-4: LYNX.SC 2XE1, 5.8 GHZ SWITCH SETTINGS......................................................................................................5-7
TABLE B-5: LYNX.HD 4XE1, 2.4 GHZ SWITCH SETTINGS....................................................................................................5-8
TABLE B-6: LYNX.HD 4XE1, 5.8 GHZ SWITCH SETTINGS....................................................................................................5-9
TABLE B-7 LYNX.HD 8XE1, 5.8 GHZ SWITCH SETTINGS...................................................................................................5-10
TABLE B-8 LYNX 2XE1, 4XE1 1.5 GHZ SWITCH SETTINGS................................................................................................5-11