5. Plug the charger into the wall outlet.
The power/charge indicator illuminates red.
When the power/charge indicator is illuminated
red, the connector is not properly connected.
In this case, disconnect and reconnect again.
6. Remove the battery charging port cap,
check the orientation of the DC connector
cord, and connect the DC connector cord to
the battery charging port.
When charging starts, the following lamps
begin flashing.
• Battery: Charge level indicator begins
flashing.
• Charger: Power/charge indicator begins
flashing green.
If the power/charge indicator is not flashing
green, the connector is not properly
connected. In this case, disconnect and
reconnect again.
7. Charging is completed when the charge
level indicator turns off and the power/
charge indicator stops flashing and turns
solid green.
Power/charge indicator
Power/charge
indicator
Cap
To Next Page
Loading...
