WinGD X92-B - Fuel pump - cutting in

10.16 Fuel pump - cutting in
Periodicity
Description
Unscheduled
Duration for performing preliminary requirements 0.0 man-hours
Duration for performing the procedure 1.0 man-hours
Duration for performing the requirements after job completion 0.0 man-hours
Personnel
Description Specialization QTY
Engine crew Basic 1
Support equipment
Description Part No. CSN QTY
Flange 94569 1
Flange 94569A 1
Roller lifting tool 94430 1
Pre-tensioner 94430A 1
Supplies
Description QTY
None
Spare Parts
Description Part No. CSN QTY
None
SAFETY PRECAUTIONS
WARNING
Injury hazard: The cutting in procedure can only be done when the engine is stop.
WARNING
Injury hazard: Before you operate the turning gear, make sure that no personnel are near
the flywheel or the engine.
CAUTION
Damage hazard: Do not operate the engine with the fuel pump removed. This will decrease
the oil supply, i.e. there could be a decrease of lubrication to the other fuel pumps.
X92-B
AA00-5556-00AAB-730B-A
Operation Manual Fuel pump - cutting in
Winterthur Gas & Diesel Ltd.
- 376 - Issue 002 2021-11