If possible, do not remove the washed crockery from the conveyor belt until it reaches the end of the
unloading zone so that it has sufficient time to dry by itself. For continuous washing, you should remove
the crockery before it actuates the stop switch and the transport is switched off.
IMPORTANT: See also point 10 “Organisation of the washing process” for information about optimum
working sequences and about hygiene in the washing kitchen. The leaflets produced by the VGG (Verband
der Hersteller von gewerblichen Geschirrspülmaschinen e.V. / Association of Manufacturers of Commercial
Dishwashing Machines, based in Hagen, Germany) are helpful in this regard.
7.2.4 Washing (MTR series machines)
Remove general debris (left-over food, serviettes, etc.) from the crockery.
Place plates, trays and the like into the washing racks with
their hollow profile facing forwards.
Place bowls in the washing racks with their hollow side
downwards.
Sort cups, glasses and cutlery into suitable washing racks.
Spray the crockery with cold water using a hand shower so
that as little debris as possible is carried into the machine.
(More debris equates to more detergent consumption).
Push one washing rack after another into the machine.
INFO: The individual zones switch on as soon as a washing rack enters the zone.
Leave the washing racks on the outfeed table for as long as possible until the crockery is dry. For
continuous washing, however, you should remove the washing racks from the outfeed table before the
stop switch is actuated and the transport is switched off.
IMPORTANT: See also section 10 “Organisation of the washing process” for information about optimum
working sequences and about hygiene in the washing kitchen. The leaflets produced by the VGG (Verband
der Hersteller von gewerblichen Geschirrspülmaschinen e.V. / Association of Manufacturers of Commercial
Dishwashing Machines, based in Hagen, Germany) are helpful in this regard.
7.2.5 Container programme
Application:
A programme for washing containers such as catering containers
Default settings:
Washing with medium transport speed (>>)
The other speeds (>; >>>) can also be selected after the start
The pump in the rinse zone is switched off
To Next Page
Loading...
Need help?
General
