7.2.6 Breaks in operation
Do not switch the machine off during breaks, so as to maintain the rated temperatures. The drive system
continues to run for about 5 minutes after the crockery has exited the rinse zone. The selected transport
speed remains set. You can continue working straight away after the break.
After the break in operation:
MTF series: Start the conveyor belt drive by pressing the round button on the end of the machine
or by using the screen, in which case you must touch one of the buttons for the transport speed.
MTR series: Push a washing rack past the transport pawls into the machine until the drive starts.
7.3 Washing with the special programmes
Various special programmes are available depending on the machine equipment level. The Winterhalter
service technician can alter the default settings if required.
Available special programmes:
Rinsing with osmosis water (can be switched on)
Rinsing with softened water and osmosis water
(cannot be changed, no screen display)
Glasswashing programme and rinsing with osmosis water (can be
switched on)
7.3.1 Glasswashing programme
Default settings:
Washing with slow transport speed
The other speeds can also be selected after the start
Pre-rinse zone (if installed) switched off
Rinsing with osmosis water (if connected)
Reduced rinse temperature
Heating of the drying zone (if installed) switched off; only with blower
INFO: Touch the button if you do not want rinsing to be performed with osmosis water.
7.3.2 Rinsing with osmosis water (can be switched on)
Default setting:
Preselected in the glasswashing programme
Can be switched on for all other programmes
Both rinse lines are operated with osmosis water as soon as the softened water has been displaced by
osmosis water in the pipes of the rinse system.
7.3.3 Rinsing with softened water and osmosis water (cannot be changed)
In all programmes, rinsing is performed half and half with softened water and osmosis water. This feature is
not displayed on the screen.
To Next Page
Loading...
Need help?
General
