Winterhalter MTF Series - Running Cleaning Programme

Maintenance and care
17
 Roof cleaning jets clean the interior of the machine with hot water from the rinse zone.
 All tanks are drained.
 The “Clean interior” button (25) flashes once all the tanks have been emptied.
If required, you can now clean the interior manually with a hose and brush. The time
shown on the button counts down from 5 minutes. The time displays when the
cleaning programme will automatically finish, assuming you do not want to clean the
interior manually.
If you do not want to clean the interior manually:
 Touch button (25).
 All tanks are drained, washed out with hot water and drained again.
 The machine switches itself off afterwards.
Cleaning the interior
Warning
Put on protective clothing and protective gloves before holding parts that are covered with tank
water (filters, washing arms, curtains, etc.).
 Open the doors and remove the curtains.
 Clean the curtains.
 Remove the washing arms (individually or in their cassette).
 Wash out the washing arms if the jets are blocked.
 Remove and clean the strainers and the filter inserts over the tank floor drains.
 If the interior of the machine is dirty: Clean the interior of the machine with a sponge and a brush.
If necessary, you can spray the interior with a hose.
 Use a brush to clean the filters covering the pump inlet openings. The filters can be removed if necessary.
 Reinsert the filter inserts into the tank floor drains.
 Reinsert the strainers.
 Reinsert the washing arms.
 Reinsert the curtains. The curtains are designed (coded) so they cannot be inserted in the wrong position.
 Close the doors.