What to do if EDM circuit did not open before transition to Machine Run state in Wintriss Security Sensors?
If the EDM circuit did not open before transition to Machine Run state on your Wintriss Security Sensors, check and correct EDM wiring.
What to do if EDM circuit was in wrong state during power-up in Wintriss Shadow 8?
If the EDM circuit was in the wrong state during power-up on your Wintriss Security Sensors, check and correct EDM wiring.
Why Machine Run/Stop LED is green but press won’t start in Wintriss Security Sensors?
If the Machine Run/Stop LED is green but the press won’t start on your Wintriss Security Sensors, check the stop relays on the Relay board on the optional Shadow 8 control box Main board.
Why Machine Run/Stop LED is not green and no object in light field in Wintriss Shadow 8 Security Sensors?
If the Machine Run/Stop LED is not green and there is no object in the light field for your Wintriss Security Sensors, try cleaning the lens window on both receiver and transmitter.
What causes EDM fault at power-up in Wintriss Security Sensors?
If there is an EDM fault at power-up with your Wintriss Security Sensors, check START input wire or EDM function selection.
What to do if there is Error in segment 2 during operation of Wintriss Shadow 8?
If there's an error in segment 2 during operation of your Wintriss Security Sensors, check connections to segment 2 and replace segment 2 with a known good segment.
What to do if safety output 1 shorted to power in Wintriss Shadow 8 Security Sensors?
If safety output 1 is shorted to power in your Wintriss Security Sensors, check and correct the wiring of safety output 1.
What to do if safety outputs 1 and 2 are shorted together in Wintriss Security Sensors?
If safety outputs 1 and 2 are shorted together in your Wintriss Security Sensors, check and correct the wiring of safety outputs 1 and 2.
Why is the Transmitter Status LED flashing on my Wintriss Shadow 8?
If the Transmitter Status LED is flashing on your Wintriss Security Sensors, check the ground wire connection and correct it if necessary. If that doesn't solve the problem, the transmitter may need repairs.
What to do if Machine Run/Stop and Blanking Active LEDs flash simultaneously in Wintriss Shadow 8?
If the Machine Run/Stop and Blanking Active LEDs flash simultaneously on your Wintriss Security Sensors, turn the Program/Run/Start key to START to clear the error. Then, reprogram the fixed blanking window, reducing the number of blanked beams.
General| Number of Beams | 8 |
|---|---|
| Housing Material | Aluminum |
| IP Rating | IP65 |
| Detection Method | Infrared |
| Operating Temperature | 0° to 50°C |
To Next Page