What to do if Machine Run/Stop and Blanking Active LEDs flash simultaneously in Wintriss Shadow 8?
If the Machine Run/Stop and Blanking Active LEDs flash simultaneously on your Wintriss Security Sensors, turn the Program/Run/Start key to START to clear the error. Then, reprogram the fixed blanking window, reducing the number of blanked beams.
Why is the Transmitter Status LED flashing on my Wintriss Shadow 8?
If the Transmitter Status LED is flashing on your Wintriss Security Sensors, check the ground wire connection and correct it if necessary. If that doesn't solve the problem, the transmitter may need repairs.
What to do if safety outputs 1 and 2 are shorted together in Wintriss Security Sensors?
If safety outputs 1 and 2 are shorted together in your Wintriss Security Sensors, check and correct the wiring of safety outputs 1 and 2.
What to do if safety output 1 shorted to power in Wintriss Shadow 8 Security Sensors?
If safety output 1 is shorted to power in your Wintriss Security Sensors, check and correct the wiring of safety output 1.
What to do if safety output 2 shorted to power in Wintriss Shadow 8 Security Sensors?
If safety output 2 is shorted to power in your Wintriss Security Sensors, check and correct the wiring of safety output 2.
What to do if safety output 1 shorted to ground in Wintriss Shadow 8?
If safety output 1 is shorted to ground in your Wintriss Security Sensors, check and correct the wiring of safety output 1.
What to do if safety output 2 shorted to ground in Wintriss Shadow 8 Security Sensors?
If safety output 2 is shorted to ground in your Wintriss Security Sensors, check and correct the wiring of safety output 2.
What to do if there is general safety output (OSSD) fault in Wintriss Shadow 8?
If you're experiencing a general safety output (OSSD) fault with your Wintriss Security Sensors, here’s what you can do: 1. Inspect the wiring to see if OSSD 1 is shorted to OSSD 2 and correct it if needed. 2. Inspect the wiring to see if OSSD 1 or OSSD 2 is shorted to power and correct it if necessary. 3. Inspect the wiring to see if OSSD 1 or OSSD 2 is shorted to ground and correct it if necessary.
What to do if every other IBI is lit on Wintriss Shadow 8 Security Sensors?
If every other IBI is lit on your Wintriss Security Sensors, correct the misalignment, then turn the Program/Run/Start key to START.
What to do if EDM circuit did not open before transition to Machine Run state in Wintriss Security Sensors?
If the EDM circuit did not open before transition to Machine Run state on your Wintriss Security Sensors, check and correct EDM wiring.
General| Number of Beams | 8 |
|---|---|
| Housing Material | Aluminum |
| IP Rating | IP65 |
| Detection Method | Infrared |
| Operating Temperature | 0° to 50°C |
To Next Page