What to do if EDM circuit did not open after transition to Machine Run state in Wintriss Shadow 8 Security Sensors?
If the EDM circuit did not open after transition to Machine Run state on your Wintriss Security Sensors, check and correct EDM wiring.
Why Machine Run/Stop LED is red and no fault code displayed in Wintriss Shadow 8 Security Sensors?
If the Machine Run/Stop LED is red and no fault code is displayed on your Wintriss Security Sensors, disable both programmable fixed blanking and floating blanking, power Shadow 8 down and then up, and realign the unit.
How to fix incorrect Operating Mode switch setting on Wintriss Shadow 8 Security Sensors?
To resolve an incorrect operating mode switch setting on your Wintriss Security Sensors, check the setting of option switch 1 on the Main Receiver.
How to fix Invalid Scan Code setting on Wintriss Shadow 8?
To resolve an invalid scan code setting on your Wintriss Security Sensors, check the setting of option switch 3 on the Main Receiver and switch 1 on the Main Transmitter.
What to do if Option switch settings changed during operation in Wintriss Shadow 8?
If option switch settings changed during operation of your Wintriss Security Sensors, turn the Program/Run/Start key switch to START, or cycle power.
What to do if Option switch settings do not match in Wintriss Shadow 8?
If the option switch settings do not match on your Wintriss Security Sensors, check to see that option switch positions 1 through 5 on the Main Receiver are set the same on both switch SWA and switch SWB.
General| Number of Beams | 8 |
|---|---|
| Housing Material | Aluminum |
| IP Rating | IP65 |
| Detection Method | Infrared |
| Operating Temperature | 0° to 50°C |
To Next Page