not present in the items of the transmitters menu (the other filters
are available)
There was an error in the phase of power ON/OFF of a link
This alarm appear when the Failsafe is activated in a receiver and
the optical signal is lost
This alarm appear when the Failsafe is activated in a transmitter
and the laser current goes out of range (the TX module doesn't
work properly)
It was detected a malfunction in the power of the booster
The laser has terminated its life time
It was detected a communication problem with the temperature
sensor of the laser module
If a problem not listed in the above table occurs or if the problem cannot solved with the proposed troubleshooting,
please contact support service at support@wisycom.com or sales@wisycom.com.
SAFETY INSTRUCTION
Read this safety instruction and the manual first
Follow all instructions and information.
Do not lose this manual.
Do not use this apparatus under the rain or near the water.
Do not install the apparatus near heaters or in hot environments, do not use outside the operating temperature
range.
Mount the apparatus as indicated in the instruction, do not block side grids for air ventilation
ATTENTION: supply the apparatus with a correct mains voltage and with the ground connection. Check the
power cord integrity.
The power cord must be protected from damage
Do not install the apparatus near heaters or in hot environments, do not use outside the operating temperature
range.
Do not open the apparatus, only qualified service technician are enabled to operate on it. The apparatus needs
servicing when it is not properly working or is damaged by liquids, moisture or other objects are fallen inside the
apparatus.
Use only accessories or replacement parts authorized or specified by the manufacturer.
Clean the apparatus only with dry cloths, do not use liquids.
The ON/OFF is a double pole circuit breaker, but to ensure the complete disconnection of the apparatus,
disconnect the power cord.
Report the serial number and the purchasing date in front of the manual. It is needed to have proper
replacement parts or accessories from the manufacturer.
When replacement parts are needed, use only replacement parts authorized from the manufacturer.
Substitution with not authorized parts could result in electric shock, hazards or fire.
Keep attention on all the labels with warnings or hazards on the apparatus.
Optical Safety!!!
Never look into the end of an optical fiber directly or by reflection either with the naked eye or through an optical
instrument. Never leave equipment with radiating bare fibers accessible – always cap the connectors.
Do not remove equipment covers when operating.
Adjustment, maintenance and repair of the equipment should only be carried out by suitably qualified personnel.
This product is supplied with angle-polished connectors and these must not be confused with standard flat,
spherical or "super" polished connectors. These connector types are not interchangeable and mating one with the
other will damage both the cable and the equipment.
To Next Page
Loading...