Why is there no inlet pressure in my Witschi ProofMaster Laboratory Equipment?
The inlet pressure may be too low. In this case, check the compressor's output pressure. Also, the maximum vacuum that can be generated depends on the current air pressure (location, altitude above sea level). The output pressure must be at least 1 bar higher than the chosen test pressure.
What to do if WiCoTRACE (SMX service) error occurs in Witschi ProofMaster Laboratory Equipment: No response received from SMX service?
If you're encountering a WiCoTRACE (SMX service) error indicating no response from the SMX service, the Ethernet cable might be defective or not correctly connected, so check the Ethernet cable. Also, the WICoTRACE configuration might not be set up correctly. Check if the SMX service is started correctly by WiCoTRACE and check the WiCoTRACE configuration.
How to fix WiCoTRACE (SMX service) error in Witschi ProofMaster Laboratory Equipment when no connection to the SMX service could be established?
If you're experiencing a WiCoTRACE (SMX service) error where no connection to the SMX service can be established, it might be due to a defective or incorrectly connected Ethernet cable. Check the Ethernet cable. It could also be that the WICoTRACE configuration is not set up correctly, so verify that the SMX service is started correctly by WiCoTRACE and check the WiCoTRACE configuration.
Why am I getting incorrect test results from my Witschi ProofMaster?
Several factors can lead to incorrect test results. The watch may not be positioned correctly. Reposition the watch. Adhesive or protective foil on the watch case can also interfere, so remove any adhesive or protective foil. Also, the watch may not be at ambient temperature. Wait until the watch has warmed up or cooled down, then repeat the test.
What to do if the test chamber of my Witschi ProofMaster Laboratory Equipment cannot be opened or closed due to pressure?
If the bell cover is open, check whether the deformation sensor is correctly fitted. If the bell cover is closed, release the pressure manually and open the bell cover.
Why is my Witschi ProofMaster Laboratory Equipment not finding the printer?
The printer may not be switched on. Check the printer and USB cable.
How to fix if test results are not being printed from Witschi ProofMaster Laboratory Equipment?
The issue may be caused by a lack of paper in the printer. Insert a new paper roll. It's also possible that automatic printing of test results is not enabled, so enable automatic printing of test results.
What causes a communication error in Witschi Laboratory Equipment, and how do I fix it?
A communication error can occur if the deformation sensor was not correctly fitted. Check whether the deformation sensor has been correctly fitted.
Why does my Witschi ProofMaster show vibration detected and unreliable measurement results?
A vibration was detected during the test. To resolve this, install the test device at a suitable, vibration-free location.
What to do if Witschi ProofMaster says no test specimen detected?
If the device indicates that no test specimen was inserted, insert test specimen.
General| Brand | Witschi |
|---|---|
| Model | ProofMaster |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
