Witschi ProofMaster - Programming a Quick Test

Use
17.10.2019 41 / 96
b
1
2
b) Press the desired program in the list.
ð The program is selected and its name1 and parameters2
are displayed.
5.2.7 Starting the test
a) Select the program.
ð See Selecting the program [}Page 40] and/or Programming a
quick test [}Page 38].
CAUTION
Observe all safety regulations for the test pressures in
order to avoid accidents and damage to the watch or the
ProofMaster!
See Safety regulations [}Page 13].
b) Positioning a watch on the support.
ð See Positioning the watch [}Page 42].
c) Press to start the test.
ð The bell cover closes and the test begins.
Info
If one of the test steps fails, the entire test is considered a
failure and is aborted immediately.
The bell cover opens.
d) Follow the test procedure.
ð See Displaying test results [}Page 45].
e) Wait until the bell cover is open.
ð The bell cover opens automatically at the end of the test.
f) Read the test result.
ð See Displaying test results [}Page 45].