Witschi ProofMaster - Selecting the Program

Use
40 / 96 17.10.2019
5.2.6 Selecting the program
Quick select
The Quick Select is used for single tests or for a single watch.
Essentially, the Quick Select is intended for a watchmaker who, for
example, wants to check a watch before or after a repair.
a
a) Press .
ð The Quick Select screen appears.
b) Program the test.
ð See Programming a quick test [}Page 38].
Programs
The programs are usually used in production to perform measurements
on a series of identical watches.
a
a) Press .
ð The program selection screen appears.