Witschi ProofMaster - Starting the Test

Use
17.10.2019 45 / 96
5.3 Measured results
5.3.1 Displaying test results
Info
As a result of a leak tightness test, only whether the test is
good or bad is indicated. However, it is also possible to
enable leak rate measurement.
See Creating a program [}Page 57].
Test area
When the bell cover is opened after a leak tightness test, the test area
is illuminated green if the test result is good and red if the test result is
bad.
Display
Two display types are available for the test result. See Selecting the
results display [}Page 47].
Numerical display
1
2
8
9
6
5
7
4
3
The numeric display provides the following information:
1 Prefix.test specimen
2 Name of the operator (only with enabled identification, in the example
above Opera)
3 Progress and result of each test step
4 Pressure values of each test
5 Measuring times of each test