3. Place the clockwork onto the clamping area so that the plate
is positioned above the signal sensor (
Fig. 22/1). Carefully
close the clamping jaw.
ð
The LED light flashes to the rhythm of the watch beats.
The measuring procedure is started.
Alternatively, the measurement can be
started via the button.
Fig. 24: Clockwork clamped in cup
Clamping clockwork (without a
housing)
Fig. 25: Crown of clockwork posi-
tioned above the signal sensor
Performing a measurement
Positioning the watch and starting a measurement automatically
27.02.2018Precision measuring device Watch ...46
To Next Page
Loading...
