Fig. 31: Setting test position designation types
There are two test position designation types available
n CH/CB/9H/6H/3H/12H
n ZO/ZU/KU/KL/KO/KR
Fig. 32: Setting the watch position
There are two watch positions available:
n CH (Dial side up)
n CB (Dial side down)
This function defines the position in which the watch has been
clamped so as to determined the correct positioning of the watch.
Positions
Watch position
Configuring the user interface
Configuring the main display
27.02.2018 Precision measuring device Watch ... 57
To Next Page
