Initial setup
16
Energy saving mode Method of operation of the coffee machine
1
Both heaters are continuously ready for use.
Coffee, milk, milk foam and hot water can be dispensed without having to wait.
2
(Factory setting)
Hot water is held at operating temperature continuously.
Coffee, milk, milk foam and hot water can be dispensed without having to wait.
The steam heater goes to stand-by after 5 minutes.
Milk, milk foam and steam can be dispensed from the Steam Jet after a short waiting period.
3
Both heaters go to stand-by after 5 minutes.
Coffee, milk, milk foam, steam and hot water can be dispensed after a short waiting period.
4
The coffee heater goes to stand-by after 5 minutes. Coffee and hot water can be dispensed after a short
waiting period. The steam heater is off.
No milk beverages can be prepared and the Steam Jet is deactiva
* Measuring method as per SAFE
> Set the time after which the machine automatically
switches off after the last beverage preparation with
–
or
+
.
> Confi rm your selection with
P
button.
For a setting at “0 Minutes“, the machine does not switch
off automatically.
> Set the result of the carbonate hardness test with
–
or
+
. (“2.3 Testing the water hardness” on page 10)
> Confi rm the water hardness with
P
button.
Sw. off time: 30 min
OK: P change: -/+
Set the switch off time
Water hardn.: 13-16
OK: P change: -/+
Setting water hardness
To Next Page
Loading...
