Initial setup
17
> With
–
or
+
, select whether you use a water fi lter
(recommended for water hardness greater than 5 °dKH)
> Confi rm your selection with
P
button.
If water fi lter is set to "Yes", the fi lter will then be rinsed.
If it is set to “No”, this step need not be carried out.
> Check to ensure that the water tank is fi led to the top.
> Place the lid on the water tank.
> Slide the water tank gently into the automatic coffee
machine.
> Place a collecting vessel with approximately 3 litres
capacity under the hot water spout.
While rinsing the fi lter, unusual noises are heard. This is
normal. The noises end during the fi lter rinse.
The machine subsequently heats up as shown in the
display.
After the machine is heated up, the coffee system is rinsed
by itself. This warms up all the pipes.
> Place a collecting vessel under the All-in-One spout for
the rinse water.
The coffee system rinsing procedure lasts for about.
40 seconds.
Water lter: No
OK: P change: -/+
Is water fi lter being used?
Place 3L container
under h. w. spout
Rinsing the water fi lter
Heating up ...
To Next Page
Loading...
