WMF 9000S+ - Software; SteamJet Cup Warmer

30
User Manual WMF9000 S +
Software | “Ready to operate” display
SteamJet cup warmer
Burn hazard/scalding hazard
• Hot steam is produced by the SteamJet cup
warmer. The cups and adjacent surfaces also
get very hot.
> Use heat-resistant cups.
> Always place acup upside-down over the
cup warmer before dispensing steam.
> Do not touch the adjacent surfaces
immediately after dispensing.
> Do not touch the spouts immediately after
dispensing.
> Never use the SteamJet function without the
drip grid in place or without the cup warmer
insert.
Health hazard/hygiene
• The SteamJet function is intended for
warming the cups and is not intended to be
used for cleaning.
> Always use freshly washed cups when
warming cups.
The SteamJet cup warmer can use steam to warm up
cups.
 Place acup on the cup warmer with the opening
facing downward
 Touch the pad
Hot steam slowly flows into the cup from below.
The jet of steam stays on for the time set in the
settings.
 Touch the SteamJet pad again
The steam jet stops immediately.
CAUTION
Follow the Safety chapter
wstarting on page 6
Clean drip tray daily
wCare
starting on page 63
CAUTION
Follow the Safety chapter
wstarting on page 6
SteamJet pad active/inaktive
wOperating options
page 42