WMF 9000S+ - Operating Options; Milk Foam Selection; Logo

47
User Manual WMF9000 S +
Software | Operating options
Milk foam selection
Options: • active
• inactive
Default value:
active
Logo
Manufacturer's logo
Options: • active
• inactive
Default value:
active
active The manufacturer's logo is shown at the top
left of the ready-to-operate display.
Customer logo
Options: • active
• inactive
Default value:
inactive
active When the option is set to “active” and
acustomer logo has been downloaded, the
customer logo is shown at the center of the
header line when ready to operate. When
vending devices are connected, it shows
the customer logo. In this case, both logos
cannot be displayed.
Load customer logo
Insert the USB stick containing the customer logo.
Load the customer logo.
Size of customer logo
The logo must not be greater than 80pixels high.
Larger logos will be scaled to this size automatically.
Milk foam selection is possible only
with AutoSteam option.