Wolf 30 - Page 53

DISPLAY CONTROL ASSEMBLY INSTALLATION
After installing the display control assembly, install:
1 Bullnose
2 Cooktop
3 Cover collar
4 Skirt
5 Oven door
Then install the unit .
Install the Display Control Assembly
1 Install the wire harness onto the display control assembly.
2 Place the display control assembly onto the display
mounting support.
3 Install the display mounting support with the display control
assembly into the bullnose.
4 Use a T-20 Torx bit to install the screws into the display
mounting support.
5 Install the lower bullnose cover into the bullnose.
6 Use a T-20 Torx bit to install the screws into the lower
bullnose cover.
30" and 36" Induction Range
Electronic Component Removal and Installation
Display Control Assembly Installation (continued)
service.subzero.com
829191 REVA
53