Wolf 30 - Page 70

INDUCTION RANGE ERROR CODES
Error
Code
Shown Phrase PRI Component Error Description Service Instruction
2 Check the voltage to the bake
element.
3 Replace the relay board.
4021 eBroilElementLoadMissing 2
1 Check the broil element.
2 Check the voltage to the broil
element.
3 Replace the relay board.
4021 eRConvElementLoadMissing 2
1 Check the right convection
element.
2 Check the voltage to the right
convection element.
3 Replace the relay board.
4021 eLConvElementLoadMissing 2
1 Check the left convection
element.
2 Check the voltage to the left
convection element.
3 Replace the relay board.
5221 ePCMAmbientExceedsTemp 3 The relay board ambient
temperature sensor is
over 216°F (102°C).
1 Check the temperature in the
relay board area.
2 Check cooling fan operation.
3 Replace the relay board.
3821 eBakeBankWiringFault 2 Right oven The incoming voltage on
an element bank is
irregular or not detected.
1 Check the bake element wiring.
2 Check voltage to the bake
element.
3 Replace the relay board.
3822 eBakeBankWiringFault 2 Left oven
1 Check the bake element wiring.
2 Check voltage to the bake
element.
3 Replace the relay board.
3921 eBroilBankWiringFault 2 Right oven
1 Check the broil element wiring.
2 Check voltage to the broil
element.
3 Replace the relay board.
3922 eBroilBankWiringFault 2 Left oven
1 Check the broil element wiring.
2 Check voltage to the broil
element.
3 Replace the relay board.
3A21 eAuxiliaryBankWiringFault 2 Right oven
1 Check voltage to the auxiliary
bank.
2 Replace the relay board.
3A22 eAuxiliaryBankWiringFault 2 Left oven
1 Check voltage to the auxiliary
bank.
2 Replace the relay board.
30" and 36" Induction Range
Troubleshooting
Induction Range Error Codes
service.subzero.com
829191 REVA
70