EasyManua.ls Logo

Wolf 30 - Page 76

Wolf 30
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INDUCTION ERROR CODES
Error
Code
Error Component Error Description Service Instruction
E 16 Unspecified generator error Generator
1 Cycle the unit electrical supply.
2 Replace the induction generator.
E 17 Unspecified primary error Primary
1 Cycle the unit electrical supply.
2 Replace the primary control board.
E 18
Unspecified left secondary
error
Left secondary
1 Cycle the unit electrical supply.
2 Replace the left secondary control
board.
E 19
Unspecified right secondary
error
Right secondary
1 Cycle the unit electrical supply.
2 Replace the right secondary control
board.
E 20
Temperature monitoring
error
Generator
0x27 = Heat sink sensor
failure.
0x36 = Temperature pin
short cut.
0x41 = Zone temperature
value invalid.
1 Cycle the unit electrical supply.
2 Replace the induction generator.
E 21 Controller error
Primary
Left secondary
Right secondary
Not a shown error. A cyclic reset
of the controller
1 Cycle the unit electrical supply.
2 Replace the primary and secondary
control boards.
3 Replace the induction generator.
E 30 Generator relay error Generator
1 Cycle the unit electrical supply.
2 Replace the induction generator.
E 31
Not valid as of V0.15 - See:
E 39
E 40
E 41
E 42
E 43
E 32 Invalid potentiometer Generator
1 Cycle the unit electrical supply.
2 Replace the induction generator.
E 33 Coil temperature sensor Generator
Two wire connection from the
coil NTC to the generator is not
connected correctly or bad.
1 Check the NTC connection to the
generator.
2 Replace the coil.
E 34 Fan 1 error Generator
Fan speed implausible
1 Check for obstructions.
2 Replace the fan assembly.
3 Replace the induction generator.
E 35 Fan 2 error Generator
Fan speed implausible
1 Check for obstructions.
2 Replace the fan assembly.
3 Replace the induction generator.
E 36 Fan 3 error Generator
Fan speed implausible
1 Check for obstructions.
2 Replace the fan assembly.
3 Replace the induction generator.
30" and 36" Induction Range
Troubleshooting
Induction Cooktop Error Codes
service.subzero.com
829191 REVA
76

Other manuals for Wolf 30

Related product manuals