5-4 How to Turn ON the Printer Rev AB
Wolke m600 touch Operator Manual
Once power is switched ON, the controller will boot-up. This will take
approximately 90 seconds, during which CLARiTY
®
startup screens
appear.
On successful boot up, the CLARiTY
®
home page appears.
Note: Following successful boot up, and on the first start up, the system
configuration wizard starts and the user is asked to set up the system. Follow
the on-screen instructions and refer to “Setting up the Printer” on page 5-7.
Note: To start the system configuration wizard manually, navigate to
Tools > Setup > Control > System Configuration. The System Configuration
dialog box appears.
Figure 5-4: Printer Power Switch
Power
Switch
(ON Position)
To Next Page
Loading...
