Wood-mizer LX150 - Tracking the Blade on Wheels

Sawmill Setup
Tracking The Blade
Sawmill Setup WMdoc122320 4-4
4
1. Ensure the blade housing cover is closed and all persons are clear of the open side of the
saw head.
DANGER! Always be sure the blade is disengaged and all persons are
out of the path of the blade before starting the engine or motor. Failure
to follow this will result in serious injury
WARNING! Make sure all guards and covers are in place and secured
before operating the sawmill. Failure to follow this may result in serious
injury.
2. Start the engine.
NOTICE: See the appropriate manual supplied with your specific
engine/motor configuration for starting and operating instructions.
See Figure 4-3.
3. Engage the blade momentarily, rotating the blade until the blade positions itself on the
wheels.
4. Disengage the blade.
5. Turn off the engine, remove the key, and check the position of the blade on the blade
wheels.
6. Use the cant control to adjust where the blade travels on the blade wheels.
NOTE: If the blade is too far out, back the blade onto the wheel by
turning the cant control counterclockwise. If the blade is too far in, turn
the cant control clockwise until the gullet of the blade is the correct dis
-
tance from the front edge of the wheel.
FIG. 4-3
LX15041-06
OFF
START
RUN
Accessories