Wood-mizer LX150 - Page 73

Sawmill Alignment
Blade Guide Arm Alignment
Sawmill Alignment WMdoc041521 8-3
8
The eccentric nut provides fine adjustments. Multiple trials may be
needed to obtain the proper alignment.
a. Loosen (do not remove) the nut inside the sawhead frame.
b. Loosen the nut between the sawhead frame and the grooved rollers.
c. Turn the eccentric nut until the roller has move the appropriate distance.
d. Tighten the nut inside the sawhead frame.
e. Tighten the nut between the sawhead frame and the grooved rollers.
See Figure 8-2. Sawhead frame members remove for illustration purposes only.
BLADE GUIDE ARM HORIZONTALLY (PARALLEL TO THE BLADE)
9. Fully extend the blade guide arm. See Fig.8-1.
10. Measure the distance between the blade and the blade guide arm near the blade guide.
11. Measure the distance between the blade and the blade guide arm near the sawhead
frame.
FIG. 8-2
LX1501-23
b. Loosen
a. Loosen
c. Adjust
ROLLER ASSEMBLY
d. Tighten
e. Tighten