General
Precautions
Read this entire manual and all other publications pertaining to
performed before installing, operating, or servicing this equipment.
Practice all plant and safety instructions and precautions.
Failure to follow instructions can cause personal injury and/or property damage.
Revisions
on may have been revised or updated since this copy was
produced. To verify that you have the latest revision, check manual
26455
,
Customer Publication Cross Reference and Revision Status & Distribution
Restrictions, on the publications page of the Woodward website:
www.woodward.com/publications
The latest version of most publications is available on the publications page. If
your publication is not there, please contact your customer service
representative to get the latest copy.
Proper Use
Any unauthorized modifications to or use of this equipment outside its
specified mechanical, electrical, or other operating limits may cause personal
injury and/or property damage, including damage to the equipment. Any such
unauthorized modifications: (i) constitute "misuse" and/or "negligence" within
the meaning of the product warranty thereby excluding warranty coverage for
any resulting damage, and (ii) invalidate product certifications or listings.
Translated
Publications
If the cover of this publication states "Translation of the Original Instructions"
please note:
The original source of this publication may have been updated since this
translation was made. Be sure to check manual
26455
, Customer Publication
Cross Reference and Revision Status & Distribution Restrictions, to verify
whether this translation is up to date. Out-of-date translations are marked with
. Always compare with the original for technical specifications and for proper
and safe installation and operation procedures.
All persons involved in the installation and maintenance of the Quick
Trip unit must have appropriate training. The calibration and checkout
procedure should only be performed by authorized personnel
knowledgeable of the risks posed by live electrical equipment.
The power supply mains should be properly fused according to the
National Electrical Code. The recommended fuse is a European Type T
fuse.