Manual 26815 QuickTrip Electro-Hydraulic Trip Block Assembly
Woodward 57
Chapter 8.
Asset Management and Refurbishment Scheduling
Period
The following recommendations regarding the Woodward designed and manufactured QuickTrip trip
block assembly are to assist in properly managing the reliability, availability and “safety of operation”
expectations established for turbines. While there are electronic control systems designed to monitor and
diagnose the operational performance of these components, control monitoring cannot replace normal
preventative maintenance practices. It is important to follow these recommendations in order to avoid
unnecessary and unscheduled shutdowns.
This product is designed for continuous operation under normal industrial operating conditions. There are
no components that require periodic service between scheduled major turnarounds (normally every five to
eight years depending on the site and application). During major outages, Woodward recommends the
QuickTrip be send back to Woodward or a Woodward Authorized Independent Service Facility (AISF) for
inspection, component servicing and to take advantage of any related hardware improvements.
Installations that do not meet “normal” industrial operating conditions may require customized
maintenance cycles to maximize reliability, performance, and asset life. Contact your local Woodward
Representative for a detailed evaluation of your site conditions to determine the right maintenance cycles
for your installation.
Woodward’s overhaul services will return the unit to “like new” condition, ready for another full operating
cycle, lasting until the next planned maintenance outage. Upon reaching the recommended maintenance
cycle of the auxiliary equipment, please contact either the site turbine OEM service representative, local
Woodward distributor or Woodward Authorized Independent Service Facility to initiate services. Refer to
Chapter 7 for Product Support and Services options.
To Next Page
Loading...
Need help?
General
