Woom ORIGINAL 3 - Adjusting the Saddle Height

To Next Page

To Previous Page

7�1 Adjusting the saddle height

To loosen and tighten the seatpost clamp, follow the assembly instructions for your woom

bike in Chapter 6.2 and the specied tightening torques in Chapter 12.



WARNING

Observe the minimum insertion depth of the seatpost! See the "Min" mark on the

seatpost. When adjusting the saddle, do not go below the minimum saddle height

(see table in Section 7.1). Failure to observe this information can result in material

damage, severe damage to health (danger to life) or death.

Saddle height measurement – see the table for the minimum saddle height.

Bike model Minimum saddle height [mm]

woom ORIGINAL 2 / 3 / 3 AUTOMAGIC 405 / 485 /485



CAUTION

Correct seat height: Sitting on the saddle, place the heel

on the pedal in the lowest position – the leg should be fully

extended. When sitting on the saddle, the child should al-

ways be able to touch the ground with both feet and have

a stable stance once the saddle height has been adjusted.

For beginners, set the saddle lower.