EasyManua.ls Logo

Woom ORIGINAL 3 - Assembling the Woom ORIGINAL 2, 3 and 3 AUTOMAGIC

Woom ORIGINAL 3
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46
EN
6�2 Assembling the woom ORIGINAL 2, 3 and 3
AUTOMAGIC
CAUTION
See Chapter 12 for the tightening torques when assembling. Failure to observe this
information can result in faulty function, material damage, dangerous situations
and injury.
WARNING (for woom ORIGINAL 3, woom ORIGINAL 3 AUTOMAGIC and
all of the woom ORIGINAL models for the US market)
Before using your woom bike, always make sure that your quick-release lever is rmly
closed. When the quick-release lever is in the closed position, you will be able to see
the word "CLOSE" on the outside of the lever.
When closing quick-release levers, make sure that they are completely closed and
do not bump against other components in the closed position. Failure to observe
this information can result in material damage, severe damage to health (danger to
life) or death.
Check your woom bike against the illustration to make sure it is complete. The actual design
of the chainguard on the woom ORIGINAL 3 AUTOMAGIC diers slightly to the illustration
shown here.

Table of Contents