47
EN
Installing the handlebars
Slide the handlebars and stem
unit onto the fork shaft as far
as it will go. Make sure that the
brake arms are facing forward.
Align the handlebars and tight-
en both clamp bolts alternately
several times until the required
torque is reached.
After tightening the clamp
bolts, tighten the locking bolt
on the top of the stem to the
required torque.
Installing the saddle
woom ORIGINAL 2
Loosen the bolt of the seatpost
clamp.
Insert the seatpost into the
frame and position it at the
desired height (see Chapter 7
for instructions on adjusting
the saddle height).
Tighten the seatpost clamp to
the required torque.
To Next Page
Loading...