EasyManua.ls Logo

wtw Multi 9420 - Page 85

wtw Multi 9420
132 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Multi 9420 Settings
ba75964e04 04/2015 85
Alternative temperature on
off
Takes the measured temperature value from an IDS sen-
sor.
This menu item is only available if an IDS adapter and an
IDS sensor with temperature sensor are connected.
Man. temperature -25 ... +25 ...
+130 °C
Entry of the manually determined temperature.
This menu item is only available if an IDS adapter is con-
nected.
pH resolution 0.001
0.01
0.1
Resolution of the pH display
mV resolution 0.1
1
Resolution of the mV display
Limit monitoring With the Limit monitoring function you define the mea-
sured values whose exceeding is signaled. An acoustic
signal sounds, and at the same time a message is output
to the USB interface.
You can switch on or off the acoustic signal in the System
menu (see section 9.6.1 S
YSTEM, page 95).
Limit monitoring/
pH monitoring
on
off
Switch on or off the limit signaling device for the pH value.
Limit monitoring/
TP monitoring
on
off
Switch on or off the limit signaling device for the tempera-
ture value.
Limit monitoring/
pH monitoring/
on/
pH upper limit
-2 ... 20 Upper limit. A message is output to the USB interface if it
is exceeded.
This menu item is only visible when the pH monitoring set-
ting is active.
Limit monitoring/
pH monitoring/
on/
pH lower limit
-2 ... 20 Lower limit. A message is output to the USB interface if it
is exceeded.
This menu item is only visible when the pH monitoring set-
ting is active.
Limit monitoring/
TP monitoring/
on/
TP upper limit
-5 ...
+105 °C
Upper limit. A message is output to the USB interface if it
is exceeded.
This menu item is only visible when the TP monitoring set-
ting is active.
Limit monitoring/
TP monitoring/
on/
TP lower limit
-5 ... 105 °C Lower limit. A message is output to the USB interface if it
is exceeded.
This menu item is only visible when the TP monitoring set-
ting is active.
Reset - Resets all sensor settings to the delivery condition (see
section 9.7.1 R
ESETTING THE MEASUREMENT SETTINGS,
page 97).
Menu item Possible
setting
Explanation

Table of Contents

Related product manuals