EasyManuals Logo

Wulfsberg FLEXCOMM II C-5000 User Manual

Default Icon
51 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
C-5000 Pilot’s Guide
Publication No. 150-041103 Page 10 of 51
Rev. C C-5000 Pilot’s Guide
Nov 2013
KEYPAD – The C-5000 has a 12 button keypad. Each button’s primary functions are described below.
1:DIR Toggles the transceiver under cursor control in and out of DIRECT mode. Use this button to enter
a “1” during keypad entry mode.
2:MODE This button will cycle through the enhanced modes of operation. Use this button to enter a “2”
during keypad entry mode.
3:EDIT This button will display the EDIT PAGE for the transceiver under cursor control. Use this button
to enter “3” during keypad entry mode.
4:DIM This button will display the page used to control the display’s brightness. Use this button to enter
a “4” during keypad entry mode.
5:OTAR This button will initiate an “Over The Air Rekey” for the transceiver under cursor control . Use
this button to enter a “5” during keypad entry mode.
6:KEY This button will prompt the user for a transmit encryption key to override the preset value for the
transceiver under cursor control. Use this button to enter a “6” during keypad entry mode.
7:TEST This button will override the squelch system of the radio under cursor control, allowing the user
to set the volume level. Use this button to enter a “7” during keypad entry mode
8:SCAN FUNCTION NOT AVAILABLE AT THIS TIME. Use this button to enter a “8” during keypad
entry mode.
*:HOME This button will display the HOME PAGE, except in some advanced modes of operation,
where it will return the user to a previous page or mode of operation. Use this button to enter a “*”
during keypad entry mode.
9:PVT This button will toggle the transceiver under cursor control in and out of private mode. Use this
button to enter a “9” during keypad entry mode.
0:PROG This button will display the programming password page. Use this button to enter a “0” during
keypad entry mode.
#:NUM This button will select keypad entry mode, such as for entering a channel number or frequency
using the keypad. Use this button to enter a “#” during keypad entry mode.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wulfsberg FLEXCOMM II C-5000 and is the answer not in the manual?

Wulfsberg FLEXCOMM II C-5000 Specifications

General IconGeneral
BrandWulfsberg
ModelFLEXCOMM II C-5000
CategoryAvionics Display
LanguageEnglish

Related product manuals