Need help?Do you have a question about the Wulfsberg FLEXCOMM II C-5000 and is the answer not in the manual?
General| Brand | Wulfsberg |
|---|---|
| Model | FLEXCOMM II C-5000 |
| Category | Avionics Display |
| Language | English |
Instructions for selecting preset channels by entering their numbers via the C-5000 keypad.
Explains how to access and tune the manual channel (channel 0) for manual frequency entry.
Instructions on how to enable or disable individual transceivers connected to the C-5000 system.
Describes how to switch between direct and repeat modes for channels on the C-5000.
Steps to permanently modify properties of a manual channel using the C-5000 Edit Page.
Explains how to change or override CTCSS (PL) and DCS (DPL) tones for channels on the C-5000.
Steps to select a DCS tone for a channel using the C-5000's Edit Page.
Explains how to establish simultaneous transmission to multiple locations using Simulcast Mode on the C-5000.
Detailed instructions for programming preset channels directly from the C-5000 front panel.
To Next Page
