CAMERA SYSTEM (LooksCAM) 33 www.xenosys.co.kr
3. Connect the equipment to the different outlets from the ones connected to other
equipments.
4. If you need expert’s help, contact to manufacturer or professional distributor.
TRANSPORTATION
1. To protect LooksCAM from any damage in transportation, pack it by plastic bubble wrap or
shipping box.
2. Load LooksCAM boxes up and down evenly by handcart and any vehicle trunk to transport.
3. When you carry LooksCAM by hand, hold it with two hands firmly and disconnect charger, and
power cord from the main body for safe transportation.
STORAGE
1. Maintain the following conditions for storing main products & components.
Environment for Operating & Storage
Environment for Transportation & Storage (Non-operating)
- External box marking will be as follows.
2. Do not pull out, twist, nor bend excessively the power cord.
3. Wind up the power cord loosely, and store it by using the rubber bandage or cable tie.
4. Do not expose the main body to excessive shock, direct ray of light and high temperature
which may cause the defective reason.
5. Caution for battery storage: As Li-polymer battery is small-sized with high power, if it is stored
fully charged condition for a long time, the battery lifespan can be reduced.
① Store it under half-charged condition in case of non-use immediately.
② Store the battery with separated from the main body in case of long-time no use.
To Next Page
Loading...
