Xerox D110

013-246
Cause: Jam or communication error with the SquareFold Trimmer Module
Remedy: Perform the following:
1. Power off/on the machine.
2. If fault persists, call for service.
013-303
Cause: A top cover is open or a jam/fault occurred with the SquareFold Trimmer Module
Remedy: Perform the following:
1. Open the Top Left and Right Covers of the SquareFold Trimmer Module.
2. Carefully remove all sheets and paper scraps from jam clearance areas.
3. Close the SquareFold Trimmer Module Top Left and Right Covers.
4. Check the Trimmer Waste Container:
• If full, empty the container and reinsert it in the SquareFold Trimmer Module.
• If the container is partially pulled out, push it completely in.
5. If necessary, follow any remaining instructions on the machine’s UI.
6. If fault persists, repeat the previous steps.
7. If fault persists, power off/on the machine.
8. If fault persists, call for service.
013-304
Cause: A top cover is open
Remedy: Perform the following:
1. Open the Top Left and Right Covers of the SquareFold Trimmer Module.
2. Close the SquareFold Trimmer Module Top Left and Right Covers.
3. If fault persists, power off/on the machine.
4. If fault persists, call for service.
013-915
Cause: Jam/fault with the SquareFold Trimmer Module
Remedy: Perform the following:
1. Open the Top Left and Right Covers of the SquareFold Trimmer Module.
2. Carefully remove all sheets and paper scraps from jam clearance areas.
3. Close the SquareFold Trimmer Module Top Left and Right Covers.
4. Check the Trimmer Waste Container:
• If full, empty the container and reinsert it in the SquareFold Trimmer Module.
• If the container is partially pulled out, push it completely in.
5. If necessary, follow any remaining instructions on the machine’s UI.
23-23Xerox
®
D95/D110/D125/D136 Copier/Printer
User Guide
SquareFold Trimmer Module