Xerox DOCUMATE 272 User Manual

DocuMate 272 Scanner User’s Guide 13
Installation
Step 3: Connect and Power On the Scanner
Connect the power supply and power cord, and then turn the
power on.
To connect your Xerox DocuMate 272 scanner:
1. Plug the power supply into the power port on the scanner.
2. Plug the power cord into the power supply and into a wall
outlet.
3. Turn on the power switch, located on the back of the scanner to
the left of the power port.
The status light comes on and flashes indicating that the
scanner is receiving power.
Now proceed to the next section, “Step 4: Connect the USB
Cable.”
NOTE: Only use the power supply (SA60-24 made by Sino-
American) included with your scanner. Connecting any other
type of power supply may damage your scanner, and will void its
warranty.

Xerox DOCUMATE 272 Specifications

General

Brand	Xerox
Model	DOCUMATE 272
Category	Scanner
Language	English