Scanning from ISIS
76 DocuMate 765 Scanner User’s Guide
Area—in this section you can select the measurement method that you
want your page size units to display. You can select Pixels, Inches or
Centimeters. When you select one of these options, the numbers in the
Page Size section will change to reflect your choice.
• Click on Snap to have the measurements round to the nearest 1/8
inch or 1/2 centimeter.
• The X and Y coordinates tells the scanner where to start capturing the
image as the page passes across the scanner glass. In the case of
“0” it is capturing the image from the center of the page, at the top of
the page.
If you have changed the starting positions of the X and Y coordinates,
the preview area will show a handling box for you to see where the
image will be captured. You can manually drag the handling box
around the screen to change the position where image capture
occurs.
To activate this option, click on the Paper Handling tab and deselect
Length Control. Click back on they Layout Tab and you will now be
able to manually enter the area where you want the image capture to
start from.
• The Width and Length areas show the size of the paper being
captured.
Page Layout—select either Portrait or Landscape as the scanning
direction of the pages in the scanner.
Feed—the options in this section are for telling the scanner what direction
the pages are facing so that the resulting image has the papers in the
proper orientation.
• Portrait—selecting portrait for the page layout activates the option for
top edge or bottom edge first. This means that if you put the pages in
the scanner with the top of the page in the scanner, then you would
select Top edge first. If you placed the pages in the scanner with the
bottoms in the scanner, then the image will be upside down if you do
not select Bottom edge first before scanning.
• Landscape—selecting landscape for the page layout activates the
option for left or right edge first. This means that if you put the pages
into the scanner with the right side of the page in the scanner, then
you would select Right edge first. If you placed the pages in the
scanner wit h the left side in the scanner, then the image will be
upside down if you do not select Left edge first.
To Next Page
Loading...
Need help?
General