EENNEERRGGYY SSTTAARR
The ENERGY STAR program is a voluntary scheme to promote the development and
purchase of energy efficient models, which help to reduce environmental impact.
Details on the ENERGY STAR program and models qualified to ENERGY STAR can be
found at the following website: www.energystar.gov.
The ENERGY STAR and ENERGY STAR mark are registered United States trademarks.
The ENERGY STAR Imaging Equipment Program is a team effort between United
States, European Union, and Japanese governments and the office equipment industry
to promote energy-efficient copiers, printers, fax, multifunction printers, personal
computers, and monitors. Reducing product energy consumption helps combat smog,
acid rain, and long-term changes to the climate by decreasing the emissions that result
from generating electricity.
PPoowweerr CCoonnssuummppttiioonn aanndd AAccttiivvaattiioonn TTiimmee
The amount of electricity that a device consumes depends on the way the device is used. This device
is designed and configured to enable you to reduce your electricity usage.
Power Saver modes are enabled on your device to reduce energy consumption. After the last print,
the device transitions to Ready mode. In this mode, the device can print again immediately. If the
device is not used for a specified period, the device transitions to Sleep mode. In these modes, to
enable reduced-power consumption, only essential functions remain active. The device takes longer to
produce the first print after it exits the Power Saver modes than it takes to print in Ready mode. This
delay is the result of the system waking up and is typical of most imaging devices on the market.
To save power, you can enable Auto Power Off mode on your device. If Auto Power Off mode is
enabled, you can configure the mode as follows:
• Always Allowed: The device powers off automatically after the specified time and the Sleep mode
timeout has elapsed.
• Allowed ONLY When Conditions are Met: The device automatically powers off only after
timeouts have elapsed. The device also powers off if Fax, USB Drive, and Wired and Non-Wired
Network have not been activated.
To change the Power Saver settings, refer to the User Guide. For further assistance, contact your
System Administrator or refer to the System Administrator Guide.
To enable Auto Power Off mode, contact your System Administrator. For details, refer to the System
Administrator Guide.
To learn more about Xerox participation in sustainability initiatives, go to: www.xerox.com/about-
xerox/environment/enus.html or www.xerox.co.uk/about-xerox/environment/engb.html.
Note: Changing the default Power Saver activation times can result in an overall higher energy
consumption of the device. Before you turn off Power Saver modes or set a long activation
time, consider the increase in device power consumption.
Xerox
®
EC8036/EC8056 Color Multifunction Printer
User Guide
335
Regulatory Information
To Next Page
Loading...
Need help?
General
