General Procedures / Information
FaxCentre F110 12/04 6-41
GP 12 Customization of the F110 FaxCentre Machine
Introduction
This chapter describes the procedure of setting the customization on a machine.
It provides information about working with customizations and further information about them.
All the following operations are done in an active Shell/Prompt like the MS-DOS-Prompt which is
used under Windows 98. The commands have to be typed and executed in the Commflag direc-
tory to work properly. The customization must be also done if you swap a mainboard with a new
one in case of a repair.
Commflag
For uploading the customization to the machine, the software Commflag is needed.
Communicating with the Machine
The communication with the machine is done via an USB cable (as usual). The difference is the
used program Commflag.
To make the machine ready for the process, it has to be entered in the test mode. Activating the
Bit switch SOS1 Bit 8 does this. To enter in the test mode press the key combination Menu # * 0.
To prevent a toner counter reset, Test Code 100 with Parameter 00 must be inserted before up-
loading a new customization file. Now the machine is ready for communication.
• Press <OK>, <*>, <#> to enter the SOS menu
• Select SOS1
• Change the bit on the left to 1: 1xxxxxx
• Press <OK>, then <C> to come back to the standby display.
• Press <OK>, <#>, <*>, <0> to enter test mode.
• Start the "Command_prompt", a DOS window should appear.
Reading the customization of a Machine
For reading the customization use the following command:
Then the output should be like this:
Sending #10112 …
#10112 sent.
Reading …
Returned: 0000040*7007
commfl #10112
This command means reading