General Procedures / Information
FaxCentre F110 12/04 6-19
GP 8 Service Functions
The FaxCentre F110 is equipped with a set of logic blocks referred to as SOS (SOFT Switch) num-
bered 1 to 30. Each block consists of 8 bits called bit 1 to 8. Each bit can take a value of either 0
or 1. On the display, a block (from bit 1 to 8) is read from right to left. When a configuration is first
selected, the blinking cursor is always placed on bit 8 (the bit at the left)
When the display shows the date and time, you can access the configuration bytes by means of
the key sequence:
Menu * #
The description of these parameters can be found below. They are modified in the same manner
as all others parameters.
Table 1: SOFT-Switch 1: Ringing and Automatic Printing
Bit 8 7 6 5 4 3 2 1
Use SOS-
IMPTRA:
Trace
printing/
PC down-
load
enable
SOS-
IMPT30:
Automatic
Printing of
T30 trace
after
comm.
error
SOS-
IMPAUTO:
Automatic
log printing
Reserved Reserved Reserved Reserved Reserved
Values 0: no
1: yes
0: no
1: yes
0: no
1: yes
Table 2: SOFT-Switch 2: Scanner / Printer Configuration
Bit 8 7 6 5 4 3 2 1
Use Reserved Reserved Reserved Reserved Reserved SOS-
BEEP:
Keyboard
beep on/
off but not
STOP key
Reserved Reserved
Values 0: beep on
1: no beep
To Next Page
Loading...
Need help?
General
