General Procedures / Information
FaxCentre F110 12/04 6-25
GP 9 Maintenance Functions
In order to use the maintenance functions, the SOS_IMPTRA switch (SOS1-Bit8) has to be set to
1. Refer to GP 8.
Go to:
• Table 1 Initialization Functions
• Table 2 Other Functions
Table 1: Initialization Functions
ITEM ACTION
Menu # 0 Default user parameters configuration (factory status) ‡ Restart with Easy
Install, GP 16
.
Directory is preserved
Pages counters are preserved
Consumables counters are preserved
Communication log is preserved
Menu # 1 Clear directory
Menu # 2 Clear communication log
Menu # 3 Clear pages counters (If page counter SOS26 / 6 is switched ON)
Menu # 4 Clear consumables counters (Attention: after clear, Chip Card is needed)
Menu # 5 Complete “hardware” reset : functions 0 + 1 + 2 + 3 + 8 ‡ Restart with Easy
Install GP 16
. This command sequence is taken into account only if printer
cover is open
Menu # 6 Same as Menu # 7 but without Easy Install GP 16
.
Menu # 7 Functions 0 + 2 + 8 ‡ Restart with Easy Install GP 16
.
Directory is preserved
Pages counters are preserved
Consumables counters are preserved
Menu # 8 Clear document memory (received documents, documents to be sent)
Clear Sending command list
Clear Printing command list
Directory is preserved
Pages counters are preserved
Consumables counters are preserved
Communication log is preserved
User parameters are preserved
Menu # 9 Same as Menu # 7
To Next Page
Loading...
Need help?
General
