General Procedures / Information
FaxCentre F110 12/04 6-49
GP 15 Installation Requirement
When selecting a location for the machine, the following points should be taken into account:
• The telephone socket should be located at no more than 2 metres (6 feet).
• A standard single-phase power socket with earth (ground) (rated in conformance with the
information on the label on the back of the machine) should be located at no more than 2
metres (6 feet).
• For easy access to the machine, leave a space of about 10 cm (4 inches) at the sides and
the back. Also leave sufficient space in front of the machine.
• If the machine is installed close to a wall, make sure the distance between the wall and
the upper edge of the tray is at least 10 inches (25 centimetres). This will allow for easier
opening of the upper cover.
• Do not install the machine in direct sunlight, near heating radiators or near air conditioning
outlets.
• The room should be adequately ventilated.
• Avoid locations where frequent vibrations occur.
• Avoid locations where water or other products might be splashed on to the machine.
• The machine should not be installed directly on to the floor.
• Place the machine on a flat horizontal support.
To Next Page
Loading...
Need help?
General
