Xerox Phaser 6280 User Manual

Managing the Printer
Phaser® 6280 Printer
148
Commands That Can Be Used in E-mail Text
Use each command according to the following rules.
• Prefix all commands with “#”, and specify the #Password command at the top of the
e-mail.
• Command lines without “#” are ignored.
• Write one command on each line and separate each command and parameter with a
space or a tab.
When the same command is written two or more times in one e-mail, the second and
subsequent commands are ignored.
Example of Commands
1. When the read only password is “ronly”, and to check the printer status:
#Password ronly
#Status
2. When the full access password is “admin”, and to set the recipient e-mail address to
“service@xerox.com”:
#Password admin
#SetMsgAddr service@xerox.com
3. When the full access password is “admin”, and to set the recipient e-mail address to
“service@xerox.com”, then confirm the setting result on the network settings list:
#Password admin
#SetMsgAddr service@xerox.com
#NetworkInfo
Note: Describe the “#SetMsgAddr” command before the “#NetworkInfo” command. If
they are written in reverse, the information retrieved by the “#NetworkInfo” command
and the result of executing the “#SetMsgAddr” command may differ.
Command Parameter Description
#Password Password Use this command at the top of the e-mail when a password for
read only or full access is set. You can omit this command when
the password is not set.
#NetworkInfo Set this when you want to check information on the network
settings list.
#Status Set this when you want to check the printer status.
#SetMsgAddr Recipient E-mail
address
Use this command to specify the e-mail address to which e-mail
reports are sent to. This command can only be used when the
full access password is specified by the #Password command.
Downloaded From ManualsPrinter.com Manuals

Xerox Phaser 6280 Specifications

General

Brand	Xerox
Model	Phaser 6280
Category	Printer
Language	English