Configuring the Network Address
Phaser® 6280 Printer
37
Manually Setting the Printer’s IP Address
Note: Verify that your computer has a properly configured IP address for your network.
Contact your network administrator for more information.
If you are on a network without a DHCP server, or in an environment where the network
administrator assigns printer IP addresses, you can use this method to manually set the IP
address. Manually setting the IP address overrides DHCP and AutoIP. Alternatively, if you
are in a small office with a single PC and use a dialup modem connection, you can
manually set the IP address.
Information Required for Manual IP Addressing
Information Comments
Internet Protocol (IP) address of the printer Format is xxx.xxx.xxx.xxx, where xxx represents a
decimal number from 0–255.
Network Mask Get this information from your network
administrator.
Default Router/Gateway address Router address is required to communicate with the
host device from anywhere other than the local
network segment.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
