Description of Menu Items
Phaser® 6280 Printer
98
USB Setup
Use USB Setup for setting the USB port’s status.
System Setup
System Setup menu is used to make the printer operation settings, such as for alarm and
power saver mode.
Item Description
Port Status Select either Enable or Disable.
Adobe Protocol Specifies the PostScript communication protocol: Standard,
BCP, TBCP, Binary, or Auto.
Item Description
PowerSaver Timer Specify the transitional time to Power Saver between 5 and 60 minutes in increments
of 1 minute.
• 5 min. to 60 min. (default: 30 min.)
• For details, refer to Power Saver Mode on page 27
Audio Tones Specifies whether to turn on the alarm when an error occurs in the printer. You cannot
adjust the sound volume.
• Control Panel (default: Off)
• Invalid Key (default: Off)
• Machine Ready (default: Off)
• Job Complete (default: Off)
• Fault Tone (default: Off)
• Alert Tone (default: Off)
• Out of Paper (default: Off)
• Low Toner Alert (default: Off)
• Base Tone (default: Off)
Fault Time-Out Sets the fault time-out function.
Time-Out You can cancel a printing process when it goes beyond a set time period. Set the time
until the print job is canceled. When this timeout expires, the print job is canceled.
• 5 sec. to 300 sec. (default: 30 sec.)
Specifies the amount of time in increments of 1 second the printer waits for
additional data before it cancels the job.
• Off
Cannot cancel.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General