Macintosh
Phaser® 6300/6350 Color Laser Printer
4-20
Macintosh
This section includes:
■ Requirements on page 4-20
■ Quick CD-ROM Install Steps on page 4-20
■ Enabling and Using EtherTalk for Mac OS 9.x on page 4-20
■ Enabling and Using TCP/IP for Mac OS 9.x on page 4-21
■ Enabling or Using TCP/IP or AppleTalk for Mac OS X, Version 10.2 and Higher on
page 4-23
■ Macintosh Troubleshooting (Mac OS 9.x, Mac OS X, Version 10.2 and Higher) on
page 4-25
Requirements
■ A workstation with the appropriate printer driver installed.
■ A working knowledge of the operating system (Mac OS 9.x or Mac OS X, version 10.2 or
higher) being used on the workstation.
■ Proper cabling to connect the printer to the network.
Quick CD-ROM Install Steps
To use the quick CD-ROM installation option:
1. Insert the Software and Documentation CD-ROM into the computer’s CD-ROM drive.
2. Double-click the installer on the Software and Documentation CD-ROM to install the
printer driver.
Enabling and Using EtherTalk for Mac OS 9.x
If you use EtherTalk, Macintosh computers do not require IP addresses.
To create a desktop printer:
1. Open the AppleTalk Control Panel. Verify that the Ethernet port is the selected network
port.
2. Open the Chooser, and then click the LaserWriter printer driver.
3. Select the printer.
4. Click Create to create the desktop printer.
To Next Page
Loading...
Need help?
General