Printer Settings
Phaser® 6300/6350 Color Laser Printer
5-4
Using the Control Panel
To select a Tray 1 (MPT) behavior setting on the control panel:
1. Select Paper Tray Setup, and then press the OK button.
2. Select Paper Handling Setup, and then press the OK button.
3. Select Tray 1 (MPT) Behavior, and then press the OK button.
4. Select the appropriate behavior setting, and then press the OK button.
Using CentreWare IS
To select a Tray 1 (MPT) behavior setting using CentreWare IS:
1. Launch your web browser.
2. Enter the printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Select the General folder on the left sidebar, and then select Printer Defaults.
5. Select the appropriate behavior setting in the Tray 1 (MPT) Behavior drop-down list.
6. Click the Save Changes button at the bottom of the page.
Setting the Duration for Tray 1 (MPT) Prompts
The Tray 1 (MPT) prompt setting specifies the amount of time the prompt displays on the
control panel after paper is loaded in Tray 1 (MPT). The Tray 1 (MPT) prompt asks the person
that loaded the paper to confirm the current tray setup or to specify the paper type and size.
To select a Tray 1 prompt timeout, use either:
■ The printer’s control panel
■ CentreWare IS
Using the Control Panel
To change the Tray 1 (MPT) Prompt Timeout on the control panel:
1. Select Paper Tray Setup, and then press the OK button.
2. Select Paper Handling Setup, and then press the OK button.
3. Select Tray 1 (MPT) Prompt, and then press the OK button.
4. Select the appropriate prompt setting, and then press the OK button.
Setting Behavior
None Turns the tray setup prompt off.
30 seconds
(Default)
Displays the tray setup prompt for 30 seconds after paper is loaded in Tray 1 (MPT).
Infinite Displays the tray setup prompt after paper is loaded in Tray 1 (MPT) until a control panel
selection is made.
To Next Page
Loading...
Need help?
General