Printing Specialty Media from Tray 1 (MPT)
Phaser® 6300/6350 Color Laser Printer
3-3
Printing Specialty Media from Tray 1 (MPT)
To verify the specialty media you can print from Tray 1 (MPT):
■ See the Recommended Media List at www.xerox.com/office/6300_6350support.
■ Print the Paper Tips page. See Determining Which Tray to Use on page 3-2.
To print specialty media in Tray 1 (MPT):
1. Open Tray 1 (MPT) by pulling out on the handle.
2. Pull out the tray extension, and open the paper guides.
3. Insert the paper into Tray 1 (MPT). If you are using preprinted or prepunched paper,
follow these guidelines:
■ For single-sided printing, place the side to be printed facedown with the top of the
page entering the printer first.
■ For 2-sided printing, place the first side to be printed faceup with the bottom of the
page entering the printer first.
■ For prepunched paper, place the paper with the holes toward the right side of the
tray.
Note: Do not load the paper above the fill line inside the tray.
4. Adjust the paper guides to fit the paper.
5. On the control panel, select the paper type and size:
a. Select Change setup, and then press the OK button.
b. Select the paper type, and then press the OK button.
c. Select the paper size, and then press the OK button.
6. In the printer driver, select either the paper type or Tray 1 (MPT) as the paper source.
7. Submit your print job.
6300-008
MAX
To Next Page
Loading...
